Falcon Protective Cover for Laser Engraver

Should be taller to accommodate add on cameras & not useful-has to come off if you use the leg risers

Everything about the unit is fine, up the point where I needed to duct the fan out of my garage. Using the fan for one test burn of my new Falcon 2-12.5 left something to be desired for getting the smoke out. Yes it does suck, but not as much as I'd like, so I installed a 4" fan from Amazon that's rated at 190cfm (probably more like 120). I did have to remove the supplied fan, and build an adapter for the 3" to 4" conversion. I'll have to go back now and build an adapter plate to keep a better seal around the sidewall and the outer duct adapter but beyond a little air leakage there it works fine now.

The carving machine is very good, but when carving some wood, because I set the power higher, always taste some smoke, using the protective cover can help me avoid this problem, let me very surprised!