Falcon Protective Cover for Laser Engraver

Great

The enclosure is a good size and well designed. The only problem I have noticed is that the plastic center joints are not strong enough to keep the fiberglass frame straight. The frame tends to say in the middle of the horizontal braces.

Should be taller to accommodate add on cameras & not useful-has to come off if you use the leg risers

Everything about the unit is fine, up the point where I needed to duct the fan out of my garage. Using the fan for one test burn of my new Falcon 2-12.5 left something to be desired for getting the smoke out. Yes it does suck, but not as much as I'd like, so I installed a 4" fan from Amazon that's rated at 190cfm (probably more like 120). I did have to remove the supplied fan, and build an adapter for the 3" to 4" conversion. I'll have to go back now and build an adapter plate to keep a better seal around the sidewall and the outer duct adapter but beyond a little air leakage there it works fine now.

The carving machine is very good, but when carving some wood, because I set the power higher, always taste some smoke, using the protective cover can help me avoid this problem, let me very surprised!